***** FBV_Enhanced *******

This SysEx emulates as close as possible the FBV Shortboard behavior, with an 'extra' feature:
the 'Manual foot setting mode' on bank #0  :-)
The Volume control is on the left pedal(A) and the Wah on the right one (B)

                    **  Banks 1 to 9  **
Pedals:

#1 to 4: Call the A to D preset with Loop 'On'... 2nd press: toggles the loop ' Off', repress 'On' & so on

#5: Tap

#6: Comp
#7: Mod
#8: Delay
#9: Reverb
#10/0: Wah

(#6 to 10/0: 1rst press: Off    2nd: On )
This is necessary because of a FCB limitation: when a patch is called, there is no way for the FCB to know which is the actual setting: On or Off ?
So, I made this choice, and the effects needed must be set 'On' in the patches themselves.
If you need the reverse, just exchange the two values (0 & 127) of CC1 & CC2.. 
It can be done very fast with the FCB Editor, preset & bank copy features)


                   ** Bank 0  'Extra' feature : Editing mode

It's purpose is editing some parameters without using the control panel knobs
As the Flex stays on the actual patch selected, this let you modify a tone, and then store it by pressing the lit button on the Flex control panel for more than 5 seconds

#1 to #4: A.I.R. settings ( both volume and wah pedals keep active)
#1 to 3 act as a toggle: 1rst press On axis   2nd press  Off axis

#1: Shure SM 57
#2: MD 421
#3: U-67
#4: A.I.R Off

#5 to #9: 1rst press: On 2nd: Off  = reverse from the 1 to 9 banks)

		    exp pedal A      exp pedal B

#5: Gate                           Threshold         Decay time
#6: Comp                         Threshold         Gain           
#7: Mod                           Tweak             Param 2 ( see manual 2.5 )
#8: Delay                          Tweak             Feedback
#9: Reverb                        Level               Decay
#0: unused.... may be customized with the FCB editor...  :-)

(*) See Flex manual, Appendix D notes 4 & 6 for Param 3 & 4 settings