***** Floorboard_Enhanced *******
Flextone II and POD use

This SysEx emulates as close as possible the Floorboardboard behavior, with an 'extra' feature:
the 'Output mode' setting on bank #0  :-)
The Volume control is on the left pedal(A) and the Wah on the right one (B)

                    **  Banks 1 to 9  **
Pedals:

#1 to 4: Call the A to D preset with Drive boost 'Off'... 2nd press: toggles the Drive boost ' On', repress 'Off' & so on

#5: Tap (Floorboard_enhanced )
               OR ( Floorboard_rvb_ctl )
#5: Reverb control: The B exp pedal controls the Reverb level instead of the wah ( First press reverb On, 2nd press Off )

#6: Distortion On/Off
#7: EQ On/Off
#8: Fx On/Off
#9: Delay On/Off
#10/0: Wah On/Off

The reverb can't be set On/Off ( should need 1 more pedal...)

(#6 to 10/0: 1rst press: On    2nd: Off )
This is necessary because of a FCB limitation: when a patch is called, there is no way for the FCB to know which is the actual setting: On or Off ?
So, I made this choice, and the effects needed must be set 'Off' if needed in the patches themselves.
If you need the reverse, just exchange the two values (0 & 127) of CC1 & CC2.. 
It can be done very fast with the FCB Editor, preset & bank copy features)


                   ** Bank 0  'Extra' feature : Output mode

It's purpose is editing some parameters without using the control panel knobs
As the Flex stays on the actual patch selected, this let you modify a tone, and then store it by pressing the lit button on the Flex control panel for more than 5 seconds

#1 to #4 ( lower) and #6 to #9 (upper):
Cabinet type ( see the manual for the order )
2 Cabs with each pedal ( 1st press / 2nd press ) except #9 ( last cab only)

#0/10: No cab

#5: unused

                           exp pedal A      exp pedal B
                           Volume             A.I.R. Ambience level